Countertop Dishwasher Tank Funnel (Euhomy)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A funnel to make it easier to fill the tank of a countertop dishwasher, such as Euhomy brand
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 147
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I love our new countertop dishwasher. I did not love filling it with water, since somebody decided that the port for filling the tank should be extremely shallow and also full of things for water to bounce off of instead of going straight in, thus splashing it all over the top of the machine to then run down the back and sides (and possibly into your electrical outlets, yikes).
This funnel drops right into the existing port, giving you a much larger, much deeper target that herds the water straight into the tank. I designed it specifically for the EUHOMY DW001-5, but it should work for any similar dishwasher, assuming your dimensions are compatible. If not, you can easily adjust the model dimensions to fit.
Printing notes:
One way or another, you'll need to use supports. Personally, I think it works best to print the funnel upright and enable snug supports. This way, the interface is all on the bottom of the funnel, and the inside surface stays smooth.
The support spacing is set to 2mm in the 3MF and GCODE files; if you're confident in your bridging and/or don't care about how the bottom of the funnel looks, you can increase that number to save filament and printing time.
With a 0.4mm nozzle, I printed at 0.3mm layer height for additional speed. You could easily go thicker with a larger nozzle.
Since this is just a funnel and doesn't need to hold water for more than a fraction of a second, I personally didn't bother to tune the printing (or paint the inside with anything) to make it watertight.
Because this will come into contact with water used to wash dishes, you should technically paint the inside with a food-grade coating. (But I didn't bother, personally.)
Funnel dimensions:
Horizontal port clearance: Outside of funnel base is 95.0mm across
Vertical port clearance: Funnel base under funnel body is 14.5mm deep
Vertical headspace clearance: Funnel body rises 80.0mm above the surface of the washer
Note that the funnel in the photos doesn't sit perfectly square because I accidentally measured all the way down to the port's filter and not just to the cross-braces that stick up from it (oops). The design posted here has been corrected to have a shorter base, so it should sit flush with the top of the dishwasher.