USC ELCT 302 car mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a model that is designed to fit on top of an old NXP Cup Car chassis for mounting breadboards.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 134
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Public Domain
This is a 3D model designed to hold 2x full length breadboards or 4x half length breadboards that mounts on an old NXP Cup Car chassis. This was designed specifically for our ELCT 302 lab at University of South Carolina, where we used these old chassis, but I uploaded it here in case anyone else could find use for the model. Note that the 2nd photo shows the mount flexing - our chassis were terribly deformed and the print would fit fine on some, and flex on others, so your mileage may vary.