1 / 3
K1c/K1/Kse Dual 360 Degree PTFE Tube Guide — zdjęcie 1
1 / 3

K1c/K1/Kse Dual 360 Degree PTFE Tube Guide

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

For use with a filament dryer and CFS with an internal Y splitter

Ocena
0 / 5
Polubienia
10
Pobrania
15
Wydruki
0
Wyświetlenia
281
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Printed with PLA

Infil  50% plus should be stong enough 

Can use with original ball if using them for just a filament roll 

Drill the ball guide out if PTFE tube doesn't fit as it's a tight fit, 4.5mm drill bit will allow the PTFE tube to easily go through. 

Glue the ring on but be careful as if you get the ball it won't be able to move.