Kitchen Sink Sponge and Soap Holder - Single Soap Slot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remixed version of a two sided sponge and soap organizer. (Heart Accents/multicolor not included in file)
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 96
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
For my needs and space constraints, the dual sided soap slots were a bit much.
Modifications:
Right hand soap slot removed completely
Bottom of the model has been filled in and merged allowing a completely flat base
Drainage scaffolding on the remaining soap slot have been filled in to decrease complexity of the print and well as my personal needs requiring a flat solid base under the soap. (Drainage scaffolding under sponge holder and straw cleaner is intact, as well as the soap slot still being able to drain through a channel to the sponge holder)
By far the best is last. I have added a small, but well functional drip edge to the end of the sink spout to prevent water from riding the bottom of the spout underneath and back onto the counter
Print Settings:
0.2mm layer height
Support is NOT needed, and will probably be difficult to remove unless using a soluble support material
Additional Upgrade:
I printed this out of PLA and attempted to use it on a Corian countertop in my kitchen. I found that either wet or dry it takes very little force to slide it across the counter. What I recommend is some 3M Self Adhesive Tape (either rubber or silicone available depending on your needs). This is the reason I filled in the bottom of the model so that there would be maximum surface area for the tape. I recommend washing and drying the bottom of your model before applying this.