Mil/USMC Compatible 1in Buckles for Packs/Slings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hardware to fix or replace most Mil-Std 1in Buckles on web gear.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 122
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Includes 2 widths, free end and loop end versions. 25mm fits 1in webbing found on most tactical gear, assault packs, main packs, plate carriers, etc. 30mm fits Vickers and similar slings. Also included is a Sling Adjuster Clip which seems to be the most commonly missing hardware on slings. *Optimized" here means it's optimized for printing. These Male Buckles print about 30% faster but don't sit flush with Female Clips on their bottom sides.
Suggested wall thickness is 3 layers, 1mm top & bottom, 15% infill - there's no reason to print thicker as that's the limit of the thickness of the hooks.
Supports on. Grid supports on build plate only. Turning threshold angle down below 30 also saves time as there are some wings on the male piece that don't need the help.
*The female piece has built in supports. These can be pulled out with pliers after printing.
All samples were printed with PA6-GF. Recommend you use something similar if you want it to do anything other than pass a once-over at CIF.