Megabot - Sitting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Loved gurol's model but I wanted it to be able to sit upright so I made new lower torso with spot for two extra…
- Ocena
- 5 / 5
- Polubienia
- 150
- Pobrania
- 157
- Wydruki
- 3
- Wyświetlenia
- 3252
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Action Figures & Statues
- Licencja
- Creative Commons — Attribution
Loved gurol's model but I wanted it to be able to sit upright so I made new lower torso with spot for two extra magnets allowing Megabot to sit upright.
Looks great on a shelf!
Print Settings
Printer:
Railcore
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
5%
Filament:
CCC3D PLA
Black Silk
Notes:
Uses 5 magnets instead of 3.
Assembled with a little 5 minute epoxy.Middle row magnet polarity should match lower magnets so legs connect to either.
Also, middle row should be done after top and bottom have set. Even with 5 minute epoxy, give it adequate time to cure. The first time I tried to set the magnets, I had two of them pull out and connect to the bottom ones. Not fun if you don't catch it and they get epoxied together!
Enjoy your sitting megabot!
Category: Model Robots