X45 Sprite Eddy Probe Mount v1.0 (Ender-3 S1 Pro and similar)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounting solution to add a BTT Eddy probe to Ender 3 S1 with as close to Zero Y-Offset as possible
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 187
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Mounting solution for a BTT Eddy probe on the Ender 3 S1 and similar Sprite extruder models.
Only tested on Ender 3 S1
Suggest ABS or similar heat resistant material. Support will be required for the alignment guide.
I printed my original X45 in PETG and when I removed it for this there was some heat damage, but it had worked fine for over a year.
For install instructions see the original model linked below.
Mount the Eddy with the bolts running from the extruder, through the mount and then through the Eddy (see picture). Clearance between the mount and the extruder is small and several small wires are nearby.
The calibration platform can help with getting the correct probe height - manually lower Z until the nozzle is holding the thin part and then secure the Eddy resting flat on the thick part.
On my machine I ended up with probe offsets of:
x_offset: -47
y_offset: 1
The Y offset is at least partly due to the need for support and the resultant low quality surface on the probe guide.
Original
