French cleat tape/square holder hanger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the original linkable french cleat hooks to make one specifically for holding squares and tape.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
French cleat holder for tape, squares, etc. It was possible to do it with the original hooks but it wasn't that stable. Also, I wanted something that allowed me to stack things further out, if necessary, to free up french cleat space.
While this is a very different model, the original linkable part design was kept. This means that, if you want, the connectors in the original design can still be used to connect multiples of this holder or with the original hooks.
There are two lengths: 52mm and 100mm (roughly 2 and 4 inches). The FreeCAD file and STEP files are included if you need a different length.
Printing: Print the holder on the side for maximum strength. No support is needed. 3 perimeters and 20% cubic infill are recommended. I also suggest some care on the direction of the cubic infill (or rotate the part) so that the cubic infill ribs support the length of the holder for maximum strength. The choice of filament is not that critical in this case, unless it has a significant exposure to sunlight or you plan to put some weight on them (e.g., two thick rolls of duck tape). In those cases PLA might be a bad choice because of its tendency to sag over time.