Dungeon Breakout board/card game box insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
New insert for the game Dungeon Breakout by Goblinko (no affiliation). Intended for sleeved cards.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 38
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution
The original insert for this game barely fits the contents of the game as they come. It definitely does not allow for sleeved cards. This insert will allow for sleeved cards with a lot of extra space. If you do NOT sleeve your cards, they will fit, but your Loot and Monster cards may end up lying flat instead of sideways. There are slots to help get the cards out but you might find this a little annoying. So I would probably add something to take up some space in those card areas, or maybe just put the loot and monster cards together in one slot.
Probably won't fit if you use oversized sleeves; only use the correct "Mini American" sized sleeves. Mini Euro will definitely not fit and Mini Chimera likely won't either. In the example photo, I have thick BCW sleeves for the Monster cards and thin Sleevekings (standard) sleeves for the Loot cards. The photo I am uploading is of a previous revision of the insert; I since tweaked it slightly but don't want to reprint it. The finger slots and the card dividers have changed a little bit to make it easier to grab cards.
I recommend manually supporting only the large cutout area on the bottom; auto support might try to support the small slots which is unnecessary. This should end up using around 200g of filament or so in total. I recommend at least three top shells. My example photo only has two, so you can see the infill. Filament used in the photo is Proto Pasta white PLA.