1 / 1
Hario Polaris Scale Heat Insulation Cover (Fixes Weight Drift) — zdjęcie 1

Hario Polaris Scale Heat Insulation Cover (Fixes Weight Drift)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A protective cover to prevent heat transfer from hot coffee carafes to the scale, eliminating weight drift

Ocena
0 / 5
Polubienia
1
Pobrania
8
Wydruki
0
Wyświetlenia
78
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial

Introduction If you use your Hario Polaris scale for pour-over coffee, you might have noticed the weight reading "drifting" or changing slightly even when nothing is being added. This is a common issue caused by the high heat of the coffee server transferring to the scale's load cell sensor.

The Solution I designed this cover to solve that problem. It acts as a thermal barrier between your hot carafe and the delicate electronics of the scale.

Key Features:

  • Ribbed Surface: The textured lines minimize the contact area between the hot vessel and the cover, improving heat dissipation.

  • Secure Slide-on Fit: The cover is designed to slide sideways onto the top plate of the Hario Polaris, gripping the platform securely so it stays in place during use.

  • Stable: Prevents the scale from overheating without affecting measurement accuracy (just remember to tare!).

Printing Instructions Since the primary purpose of this model is to handle heat, material choice is critical.

  • Material: DO NOT use PLA. It will likely soften and warp under the heat of a coffee pot.

    • Recommended: PETG, ABS, or ASA.

  • Orientation: Print sideways (standing on its edge).

  • Mode: Use Spiral Vase Mode (or "Spiralize Outer Contour"). This achieves a completely seamless print with no Z-seam.

  • Line Width: Set your extrusion line width to 0.7mm - 0.8mm (this can be done even with a standard 0.4mm nozzle). This ensures the single wall is thick enough to be sturdy and rigid.

  • Supports: No supports required.

  • Brim: Required. Since the object is quite thin when printed sideways, you must add a brim to ensure it adheres well to the build plate and doesn't topple over.

Tagi