monorail half track
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Building Toys
- Licencja
- Creative Commons — Attribution — Noncommercial
A half-length track for the lego monorail system. It's in the same style like the quarter track I designed earlier.
Works fine with only supports in the corners (for the elevated corner-parts and the studs).
Safes a ton of printing time if you don't place supports under every hexagon.
I use the grey BASF Innofil3D PLA by now, it has a pretty neat color and texture. It is more like the new light grey bricks than like the original color but it's the best match I could find by now. If you have material suggestions just leave a comment :).
I just added a support-blocker template that yoou can use in Cura (or maybe anywhere else also) to block all but the corner supports.
Print Settings
Printer Brand:
Ultimaker
Printer:
Ultimaker 3
Rafts:
No
Supports:
Yes
Resolution:
0.15mm
Infill:
20% ZigZag
Filament: BASF Innofil 3D PLA Grey
Notes:
Less infill might also work fine, I just use 20% by default.
Also a higher layerheight will be fine, just don't do to high because of the studs on the side.
Supports should only be placed in the corners. You can use the blocker-template to make that easier.
Post-Printing
A bit postprocessing will be necessary since the side-studs won't be perfectly round.
Also depending on your printer and filament the fits on the bottom can be quite "press fitting", be careful not to break anything.
Category: Construction Toys