120 Film Holder, 5 Slot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My 5 slot 120 film holder design, to take unwrapped film rolls
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 64
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This was the first model I set out to make after I bought a 3D printer, and it has taken me months to nail the print settings.
This is my design for a 5 slot 120 roll film holder that corrects for a few complaints I have with commercially-available options:
It takes film still in the wrappers, which is good because that keeps it fresher and that's where most companies print the expiry date
It's long, rather than wide, which makes it easier to pack or put in a pocket
It's a snug press-fit, requiring no magnets or extra parts, and the films don't rattle about inside
The fit will be looser in cold weather, but that's to prevent it jamming in hot weather. It's friction-fit with grooves on the ends to prevent excess suction (as the fit is quite precise). I print mine in PolyMaker PolyTerra PLA and mix/match the lids and bodies!
Now the print settings are a bit of a nightmare - I have a lot of banana-shaped prints of these from perfecting it. You need some seriously good bed adhesion to print this without a brim (and even with a brim), but once you nail it you get a really nice finish with zero waste.
The main trick for me was increasing the first layer height and width, to 0.28mm and 0.8mm respectively, and slowing the printer down to 10mm per second for that first layer. I'm also using a smooth PEI plate (the PLA-only side on the default Elegoo plate) with 65º bed temp for the first layer and 55º for subsequent layers. It's easier to print the two parts separately, but it can be achieved in one print so long as you print in layer-order, not object-order. Object-order leaves one part sat at full height for too long whilst heated and it lifts at the ends.
In terms of other settings, I use 3 walls, arachne wall generator, inner/outer/inner order, and ironing with 30% flow rate. For infill I find 15% grid or cubic seems to work well. These are settings for my Elegoo Centauri Carbon so your mileage may vary.
I've attached my OrcaSlicer settings files. If you find any other tricks to get them printing easier then do say so in the comments!
Too much film space? Check out my 3 slot version (and it's easier to print too):