Delta Flyer - Two-Piece Bottom Frame Spacers & Bed Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
separation is good sometimes
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 119
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This mod replaces the three stock bottom frame spacers with a modular, two-piece design. By separating the Frame Spacer from the Bed Mount, you gain the flexibility to use different materials for different functional needs.
Why use this mod?
Material Efficiency: Print the visible frame spacers in aesthetic or "fancy" filaments (like PLA or Silk) to match your build’s theme.
Heat Resistance: Print only the bed mounts in high-temp materials (PC, ASA, or Nylon) to handle the thermal stress of a heated bed without warping the rest of the frame.
Serviceability: Easily swap or adjust bed mounts without needing to disassemble the entire bottom frame assembly.
Hardware Requirements
To install this mod, you will need the following hardware in addition to the stock components:
6x M3x5x4mm Heat-set Inserts
6x M3x16mm Screws
Installation Notes
Install the heat-set inserts into the printed spacers.
Secure the bed mounts to the spacers using the M3x16 screws.
Replace the three stock bottom frame spacers with your new modular assemblies.