Okai Neon Pro iPhone 13 w Case Clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Iphone 13 pro mount for okai scooters
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 16
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
Custom phone mount designed specifically for Okai electric scooters.
This mount securely holds an iPhone 13 Pro with a standard protective case.
It features a snug side-tab design with a front top retention lip to prevent the phone from
sliding or popping out during bumps or vibration.
The two-piece clamp wraps around the horizontal scooter bar and tightens using standard M4
hardware, making it strong, adjustable, and easy to install or remove.
This is my first MakerWorld upload, feedback and improvements are welcome.
Required Hardware:
• 6× M4 screws (30 mm length recommended)
• 2 × M4 hex nuts (or M4 nyloc nuts for vibration resistance)
Material: PETG (recommended for outdoor use and vibration)
Printer: Bambu A1 / A1 Combo
Layer Height: 0.24 mm
Wall Loops: 5–6
Infill: 35–40% (Gyroid)
Supports: Yes
Brim: Yes (6–10 mm)
Orientation: Print 2 pieces flat as and main holder on its side at 45 degrees
• Do not overtighten screws
• PETG recommended over PLA for heat resistance
• Check fit before riding