1 / 11
Hanger Clamps For 4" Outlet 7.8" Diameter Carbon Filter For Indoor Garden / Air Filtration System / Grow — zdjęcie 1
1 / 11

Hanger Clamps For 4" Outlet 7.8" Diameter Carbon Filter For Indoor Garden / Air Filtration System / Grow

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These clamps are designed to fit a carbon filter with an outer diameter of 7.8"

Ocena
0 / 5
Polubienia
79
Pobrania
170
Wydruki
0
Wyświetlenia
1481
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

These clamps are designed to fit a carbon filter with an outer diameter of 7.8". These types of filters usually feature a 4" intake/outlet flange, and are often used in indoor gardens, and airbrushing fume hoods. They feature a small flat foot on one side to aid in aligning the rings before tightening things down.

These Clamps work best on filters that use a pre-filter over the perforated metal outer casing. If you do not use a pre-filter (you should), you can glue on a few strips of craft foam or craft felt to the inside of the rings to take up the small amount of gap.

Fits this type of filter: 4 Inch Air Carbon Filter - https://amzn.to/3oKfAjm 

Which is also found in this kit. - https://amzn.to/3bAgYBv 

Uses M3x3mm knurled brass heat-set inserts found here - https://amzn.to/2LQwDld 

Uses 1 M3x6mm screw found in this kit - https://amzn.to/39q2otO 

*Note: This post contains Amazon Affiliate links that support The Makers Workbench via a small commission from any sales they help generate.

Design File Included: .stl .f3d, step, .skp and obj files. 

Follow The Makers Workbench on:

I have only tested this model using the default 0.20mm Linear Advance preset in Prusa Slic3r 2.2.0 with the following amendments made.

  • 8-perimeters
  • 5-top layers
  • 5-bottom layers
  • 20% infill
  • Gyroid Infill
  • Concentric Top and Bottom Pattern

Print time on a stock Prusa i3 MK2s is about 2-hours 32-minutes and uses an estimated 61.81-grams of PLA filament.

PLA Used: Polymaker Polylite PLA - https://amzn.to/3mTrbuU 

Tagi