1 / 7
Star Wars AT-AT Style Pen Pot with Secret Compartments Inside — zdjęcie 1
1 / 7

Star Wars AT-AT Style Pen Pot with Secret Compartments Inside

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Star Wars AT-AT Style Pen Pot with Secret Compartments Inside

Ocena
0 / 5
Polubienia
1
Pobrania
5
Wydruki
0
Wyświetlenia
49
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I wanted an AT-AT style pen pot for my desk, originally with a head and legs but ened up scrapping that idea as it was too high/taking up too much space. I do however have the parts made/remixed from someone elses models and if enough people want them I could upload them, though I haven't tested them for fit etc.

The recesses on the bottom were for the legs, but I just put some small strips of rubber in them instead to use as feet.

I printed the model with no supports, but you could use them if you want (I had a couple of tiny inperfections on the ends where it's sunk in) but it was literally a couple of bits of filament I just snapped off. If you want it to print without worries, then perhaps use supports as it is quite a long print. The downside would be you'd then have to clean up where the supports touched lol!

I originally made the holes on top/lid for magnets (8 x 5mm x 3mm), but on glueing them in found they are really way too powerful lol, so I have included some posts to use instead, or as well, maybe use a magnet/post combination!

Inside are 2 trays (print the same one twice) which hide deeper storage compartments on each side.

I suggest as always with items with shallow slopes or radiuses to use adaptive layer height set to 0.3 and smooth maybe 4 times in Orca slicer for a nice print, it takes longer but looks much nicer. Presumably other slicers have the same sort of settings.

Tagi