1 / 4
Spill guard for Dacor Gas Cooktop- Discontinued part, exact replacement — zdjęcie 1
1 / 4

Spill guard for Dacor Gas Cooktop- Discontinued part, exact replacement

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Refurbish your Dacor spill guards - the thin bezel behind the gas on/off knobs.

Ocena
0 / 5
Polubienia
0
Pobrania
16
Wydruki
0
Wyświetlenia
49
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution

I got asked if I had a  model for the spill guards for a Dacor Gas range.  Since I had previously published the file for the Dacor Gas range knob set, I decided to make a model so you can print your own spill guards.  Dacor no longer makes them, and they're a devil to find.  Now you can print your own.

The printing is done in two parts.  part B is the forked part that goes into the stove and holds the spill guard in place.  It is keyed - there is one fat fork tine that aligns with the down position in the gas range top plastic face.  

The second part is the front facing decorative part that actually stops spills from going inside of the range top.  This one prints in two colors - if you use the model provided for part B as with prusa slicer and "open project" the color change is already set up for you.

No supports are required.  I recommend using PETG because it's a range top and gets warm.  Also PETG is much easier to glue the two parts together.  To align, put some glue on the forward facing part of part A.  I prefer the scigrip 16 solvent glue as it holds PETG well and dries quickly, but not too quickly.  Then make the on-off symbol be the TOP of the outside trim piece, and the fat fork at the opposite end, and center the holes.  They are quick prints so you can redo if the glue sets too quickly.

Then once glued, insert fork side in, fat pin down, and now the stop-symbol at the top.  it fits right in and is just about as tight as the original part.  Then put the knob back on the shaft and you're done.

Tagi