Kabeldurchführung mit Zugentlastung/ Cable entry with strain relief
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
hier für/ here for “PrintClosure Project”
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 105
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Dies dient zur Kabeldurchführung und Zugentlastung eines 3,5 mm dicken Rundkabels des Lüfters vom HEPA-Filtersystem im Rahmen des „PrintClosure Project”. Die Bohrung im Grundmaterial (hier eine 3 mm dicke Acrylglasscheibe) hat einen Durchmesser von 20 mm. Die Befestigungsbohrungen sollten einen Durchmesser von 3,5 mm haben. Es werden drei Zylinderkopfschrauben M3 x 12 mm inklusive Muttern benötigt. Bei stärkerem Grundmaterial müssen die Schrauben entsprechend länger sein.
Translation: DeepL
This is used for cable routing and strain relief for a 3.5 mm thick round cable from the fan of the HEPA filter system as part of the “PrintClosure Project.” The hole in the base material (in this case, a 3 mm thick acrylic glass pane) has a diameter of 20 mm. The mounting holes should have a diameter of 3.5 mm. Three M3 x 12 mm cylinder head screws including nuts are required. If the base material is thicker, the screws must be correspondingly longer.