1 / 4
Holga 120 film cover retainer
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holga 120 retainer to prevent the unintentional opening of the back
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 130
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Does the back fall off your Holga? Are you tired of taping it shut? Then this device is for you. It snaps on to the back of your Holga camera to ensure the back stays attached. When you are ready to change the film it snaps off just as easily. The smaller retainer has been tested on a Holga 120n and Holg120 GFCN but should fit most standard models. The larger retainer was made to fit the Holga 120Pan. I have printed it in PLA and PETG and either seems to be fine.
