Blink Mini Adapter for Original Prusa Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This piece will replace the small metal "puck" in the Blink Indoor Mini camera, allowing you to wall-mount the camera
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 43
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
To mount this, use a M3x25 bolt and hex nut (depression included) to bolt into the enclosure. I'd recommend routing the Blink power cable through the bottom of the enclosure and BEHIND the mount prior to bolting it into place.
With the Blink Mini base, use a spudger to remove the sticker at the bottom of the base, you'll find a small metal "puck" that is snapped in by two plastic tabs. Use the spudger to pop it out, and the circular portion of this model should snap right in.
There are many bolt-holes in the flat corners of the enclosure, the square portion of this model is setup to fit snug between them and provide a lot of placement options. I used the center-left because it stays clear of any moving parts (pictured)
I used PLA for the prototype, but probably should use PETG/PC long-term as it gets toasty warm in there.