Mini Basketball Hoop (Multicolor, no MMU)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a design i threw together for a miniature basketball hoop
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 89
- Wydruki
- 0
- Wyświetlenia
- 264
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Share Alike
I got a basketball shaped stress ball that is approx. 70mm wide and wanted to make a mini hoop for it. Technically anything under 75mm would fit, but beyond that it'd be too hard to make any baskets.
The design is in 3 parts. Print the rim in PETG with minimum 4 walls. The backboard and lines can be any material. Ideally turn your ironing on. It snaps into place, or you can use a little cyanoacrylate (super glue) to secure it all together. Without glue, the backboard stays together fairly well due to tight tolerances. If your printer is not well tuned, these tolerances may be too tight and you may want to sand the parts before assembly.
Use a command strip to hang on your wall and start shooting! Down the line I may come back to this design to make an automatic ball return kicker/chute.