1 / 1
Replica of Grenadier Wizard's Room 2009C Miniature — zdjęcie 1

Replica of Grenadier Wizard's Room 2009C Miniature

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a replica of figure C from the box "Wizard's Room", number 2009 from Grenadier (see…

Ocena
5 / 5
Polubienia
8
Pobrania
24
Wydruki
1
Wyświetlenia
142
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
People
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a replica of figure C from the box "Wizard's Room", number 2009 from Grenadier

(see http://www.dndlead.com/grenadier/ADandD/2009.jpg )

Reproduced using https://www.thingiverse.com/thing:1762299

"Work desk w/ components"

This shipped as a 2-piece model. Since I did not glue the 2 pieces together, I was able to scan them separately, which was good because I don't know how I would have imaged the underside of the table otherwise. Two separate model files are included. They are sized slightly differently, so pay attention to the printing instructions.

Note that I had considerable difficulty printing this model, with Cura disconnecting from the printer, printer stopping midprint, failing to extrude filament properly, etc. I suspect that the wizard has put a curse on the table. You have been warned!

Print Settings

Printer Brand:

Monoprice

Printer:

Maker Ultimate

Rafts:

Yes

Supports:

Yes

Resolution:

0.1mm

Infill:

25%

Filament: eryone PLA white


Notes:

I had to use a raft for the table top, otherwise it warped.
Print at 185% to match original, set Z = -0.2mm

Table legs require supports. Print at 195% to match original.

My printing fellow suggests printing the legs upside down, and sunk slightly into the build plate (perhaps -0.2mm) to make the surface flat, so the table top rests on it smoothly. Sounds good to me!

Category: Scans & Replicas

Tagi