1 / 8
Valentine mini photo frame "Liebe"/"love"/"l'amour" (9cm x 6cm; no supports) — zdjęcie 1
1 / 8

Valentine mini photo frame "Liebe"/"love"/"l'amour" (9cm x 6cm; no supports)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A mini photo frame 9cm x 6cm with hearts and the word "Liebe" (or "love" or "l'amour"). Printable without supports.

Ocena
5 / 5
Polubienia
3
Pobrania
21
Wydruki
1
Wyświetlenia
64
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a little (9cm x 6cm) mini photo frame consisting of 2 parts:

  • Front part. With heart shaped hole for a photo.

  • Back part. With a small stand.

Printing:

The whole model is designed that it can be printed without supports (if your printer can print at least 45 degrees overhang without supports; most FDM printers can do this).

The back part should be printed using PETG and a layer height of 0.1mm (or less) since it has 2 tiny hooks attached which require some special care when printing and bending.
I had some problems when using a brim so I did the final printing of the back with "mouse ears" at the edges to prevent warping effects and didn't use a brim.

The front part is less delicate. Use PLA or PETG and a layer height of 0.2mm. A brim should be used to prevent warping (or use "mouse ears" too).

Mounting

Bend the hooks of the back part (carefully).
Put the front upside down and lay the photo on it. Then mount the back part by putting the hooks into the holes at the upper and lower part of the frame.
A small screwdriver can be helpful here.

Once the hooks snapped in the frame is ready.

Enjoy.

Design tools used

  • OpenSCAD

  • Pen

  • Paper

  • Brain 

Changes

  • (2026-02-07) Add additional STLs for the front parts with the labels "love" and "l'amour". Add photos with these front parts, too.

Tagi