Prusa CORE One L PolyDryer/SnapDryer shelf

Prusa CORE One L PolyDryer/SnapDryer shelf pair that each attaches with a 3M Command large adhesive strip.

It’s a compact design using minimal filament and doesn't require magnets or screws. The Prusa CORE One L has enough vertical space on the right side for the shelf, the PolyDryer/SnapDryer dock + box, and the larger 10% version of the air exchanger.

Print orientation

Print Prusa_CORE_One_L_PolyDryer_shelf.stl with the top face of the shelf facing down on the print bed. Supports are unnecessary.

Materials

• PETG or ASA filament; PLA might work.

• 2 × 3M Command large adhesive strip.

Print settings

Prusa Slicer print settings preset 0.20mm BALANCED @COREONEL, modified:

• Layers and perimeters

  • Vertical shells

    • Perimeters: 3

• Infill

  • Infill

    • Fill pattern: Gyroid

Assembly

1. For each shelf, attach a 3M Command large adhesive strip to the underside, with the rounded pull-tab pushed into the corner to act as padding against the vertical face.

2. Remove the bottom covers of the adhesive strips.

3. Hold the shelves under the PolyDryer/SnapDryer dock with its rubber feet in the shelf sockets.

4. Adhere the shelves and dock to the side of the printer, ideally as far back as the dock cord allows for the shortest possible filament tube from the front top of the dryer box into the printer.

5. If you have the air exchanger, place it on the dock.

6. Dock the dryer box.

7. Insert a PTFE filament tube in the side of the printer, and cut it to length to fit into the front top of the dryer box.