YA3DSTT yet another 3D scan turn table!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just in case yet another 3D scan turn table were needed... here we go. Please observe the CC+attrib+non-commercial…
- Ocena
- 4 / 5
- Polubienia
- 28
- Pobrania
- 279
- Wydruki
- 2
- Wyświetlenia
- 1828
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
Just in case yet another 3D scan turn table were needed... here we go.
Please observe the CC+attrib+non-commercial license. Don't try and make money off my hard work. If you want to create derivative work I provide the Tinkercad design. Please pass on the CC+attrib+non-commercial license to any derivative work. Thank you.
Needs a 22mmx8mmx7mm bearing like this.
It's so simple to print even I could do it, please post makes! :)
Print Settings
Printer:
Sovol SV01
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
10% gyroid
Filament:
Sovol3D PLA
Black
Notes:
Push the bearing into the base by holding the base upside down and pressing against a clean, smooth wood board.
The turn table axle should be quite easy to insert. If additional girth is needed wrap a little electrical tape or scotch tape around the axle.Category: 3D Printing