ultrabook stand - vertical (open 180º)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Initial upload 2-15-21: A stand for Dell Latitude Ultrabook for the fully open laptop (180º) to allow raising it to…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 145
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
Initial upload 2-15-21: A stand for Dell Latitude Ultrabook for the fully open laptop (180º) to allow raising it to eye level while using an external keyboard and mouse. This configuration saves a ton of desk space. Have used every day at work and home since printing it. It's surprisingly stable and unobtrusive.
Use Rev.1 0.5 mm wider gap for not as snug a fit in case the rubber feet on the back of your ultrabook are brand new and protruding too much.
Please note the share alike + non commercial license. Please don't try and make money off my hard work.
If you want to modify and create a derivative I provide the original Tinkercad design. Please pass along the CC share alike non commercial license to any derivative work.
Update 4-20-21: Use V2 for a faster print (3 hrs vs. 5-6 hrs) and slightly less material used. (tinkercad here)
Update 8-17-21: have been using both designs daily, V1 at work and V2 at home since February 2021, with zero issues with either design.
It's so simple to print even I could do it, please post makes! :)
Print Settings
Printer:
Sovol SV01
Rafts:
No
Supports:
No
Resolution:
0.2 to 0.3 adaptive (Cura)
Infill:
10% gyroid to 15% rectilinear
Filament:
Sovol 3D PLA
White
Notes:
Category: Computer