CNC 1610 Z carriage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I managed to strip the bolt for tightening the spindle on my Linksprite 1610 CNC. I decided to take the time to model…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 222
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I managed to strip the bolt for tightening the spindle on my Linksprite 1610 CNC. I decided to take the time to model up an entire replacement carriage (with help from a few measurements).
Features:
- the carriage is entirely parametric.
- It features a lifted spindle clamp to increase clamping surface when using an ER11 collet, which tends to be longer than the stock collet.
- it uses a GoPro knob for clamping the spindle (25mm M5 bolt and M5 nut).
- (optional) The wide body version basically has Despair's Z endstop plate built in on either side, plus a cable tie mount point.
- (optional) built-in dovetail mounts on either side of the spindle for accessories like dust collection and camera mounts. Still designing those bits.
There's several versions; a wide-body version with a lifted clamping section, dovetail mounts, and endstop mounts, one without the lift, and something close to stock with just the improved front clamp.
I've included a trivial block for removing the LM8UU bearings without damage (they're not in too tight). The screw nut is a bit tighter, but still pops out easily enough.
Print Settings
Supports:
No
Infill:
30%
Notes:
Printed in Hatchbox PETG
Category: Machine Tools