MakerFarm i3v adjustable Y idler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tried http://www.thingiverse.com/thing:612584, did not like. It was awkward to assemble and knocked about 10mm off my…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 136
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Tried http://www.thingiverse.com/thing:612584, did not like. It was awkward to assemble and knocked about 10mm off my Y travel.
This is as simple as adjustable gets. Put a couple M3 nuts in the forward slots. Ideally, you'd leave a couple of 10mm M3 set screws in, but I don't have any handy.
I use longer M3 bolts, tighten down the belt, then lock the M5 bolt (with extra washers on the bearing sides to avoid rubbing) and remove the M3's so my Y travel isn't restricted. So far it hasn't budged.
Because the tension on both sides is independently adjustable, it's easy to tweak the belt tracking so it stays centered.
Print Settings
Printer:
Makerfarm i3v 8
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
50%
Notes:
Natural PETG.
Category: 3D Printer Parts