K2 Plus 100x108/100x104 Chamber heat duffuser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a heat Shield for the 100x108 and 100/104 V2 versions.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 42
- Wydruki
- 1
- Wyświetlenia
- 205
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I found that for tall, heated chamber prints, the part can be affected by the chamber heater cycling on and off… I remixed the add on HEPA filter snap on covers a simple rectangular shield that directs heat up and down instead of at the part. This part simply clips over the Filter cover and can be removed for filter swaps.
Printed in PPA-CF due to the heat from the rear fan up to 130c. ASA or ABS would also be fine to use for heat shield, PETG may warp on prolonged high chamber temp prints .
Walls 4
infills 100%
V2 21/05/2026
I Have now added a V2 Shield with a closed top. This stops heat going directly to the Temp sensor. Advised to use a High Temp filament like PET-CF, PPA-CF and PPS-CF as there is now only one pathway out for the heated Air.