Roxon Flex Companion extra bit holder / holster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds 4 extra 1/4" bits on the side of a Roxon Flex Companion multitool.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 90
- Wydruki
- 0
- Wyświetlenia
- 655
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Public Domain
This is a holder / holster to carry 4 extra 1/4" bits for a Roxon Flex Companion. It is held in place by the bit in the built-in bit holder, and slides off easily when you pivot the bit holder out to use it. It also fits back into the same spot when the bit holder is open, held in place by friction against the liner lock, so you don't have to set it down or put it in a pocket etc, when using the bit holder.
It is designed to use 1" bits, the 1.25" bits will fit, but the bits could catch on things in your pocket, straps, etc. That is also why I extended the walls so far, to keep the tips from scratching you, catching on things, etc.
It is designed around a standard 6x3mm round magnet (needs 2), and it pops into place with a little effort, and that holds the bits in place. (It's not super secure, but it's enough to keep the bits from falling out in your pocket. Probably not good enough if you throw this into a toolbag, or it's rattling around in a glovebox.)
This is designed to print standing up, you only need supports under the short piece. The internal bridges around the magnets should print fine. I originally had the short piece all the way at the bottom, but then the top bits extended far enough to press against the lock mechanism and made it difficult to unlock the tools.
(Yes I plan to modify this to work with 4mm bits on the Mini, I have ordered one and will work on that as soon as it arrives.)