Pikachu themed panels for BeamCase SW
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Side and Top panel for short BeamCase SW
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 100
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
This is Pikachu themed side panels for a custom size BeamCase SW.
These panels are meant to go with the models listed below to get a complete Pikachu themed PC. The panels are only sized to fit the case using the 205mm beams and with a HDPlex GaN 250W PSU.
You will need to purchase the BeamCase SW to fully complete the case, as I am only providing a few alternative pieces. These are made for BeamCase SW v3.0.
There are two options for the right panel - either with a Pikachu cutout or just using lighting bolts.
I run the case without a bottom panel. The top panel can be used as a bottom panel if neccessary.
I have also uploaded a step file of the blank top panel in case you want to apply your own pattern. The best way to do this in Fusion 360 at least is to apply an SVG with a pattern (of which you can find many online) to the area that's been raised by 0.01mm in the file, and then extrude (cut) out any holes you want.