Dodge wheel hub cap center cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a replacement hub cap for Dodge wheels. Snaps into place does not need to be held on by lug nuts. Includes test
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
This is a replacement hub cap for Dodge wheels. This is for wheels with an opening of 155mm and an inner diameter opening of 146mm. The wheel is 6x4.5 lugs. There is a inner lip about 1mm thick that will lock the hub cap in place. First few times removing it will be tough but will loosen up after a few.
Used ones on ebay go for around $15-$30 a piece now you can print your own.
There is three versions of this model. One is a quick print to test if the scale and fitment are correct for your wheel, the other one has an opening to allow your lugs nuts to pass through and the last one has most of the openings covered.
I recommend printing this in an upright orientation to reduce the amount of support material needed and to have your print lines not parallel to the inner lip that snaps into place. Also pair it with Dorman lug nut 611-154 if you plan to go with the cap that conceals the lug nuts
Test fit PLA will be fine, but for long term use PETG at a minimum, but stronger filaments will always be better.
Original work made by PaskeyIndustries on Thingiverse.