Skadis sewing thread and bobbin holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a smaller footprint remix where the bobbin holder part is lower and spool is closer to the board.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 113
- Wydruki
- 2
- Wyświetlenia
- 325
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
I created this remix so that the pieces could be installed directly on top of each other on the peg board without the bottom of the top piece's thread holder blocking access to the bottom piece's bobbin holder.
Note that with the bottom thread holder part being shorter and the bobbin part being lower, it will likely not work as well with larger spools; the remix was made and tested to work for Aurifil 1422 yd spools. The bobbin holder also only works for regular sized bobbins (~20mm, Class 15/Class L) and NOT larger ones!