ZWQ - Kitty Cat Magazine Bumper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cute replacement mag bumper for the thin ZWQ magazine
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial
A replacement mag bumper for the thin, talon geometry, ZWQ mags.
Fit is semi loose, I've printed these in PLA+ so I wasn't after a friction fit.
I can add a tighter fir for TPU or other soft materials if people want it, just leave a comment.
Tools required:
Pliers
Awl or similar metal push pin with a Ø2mm or smaller head
2mm drill bit (optional)
Installation:
1. Using the awl, push out the pin from the smooth end and extract it with pliers
2. Take off the OEM bumper and replace with the Kitty Cat 'Bumper Body'
3. Line up the 'Bumper loop' and reinsert pin until flush.
If you end up cracking the bumper loop, try sizing the hole up with a drill bit or rat tail/round needle file. You could alternatively heat the pin up until very warm and press fit the pin in place.