Spice Stairs w/ Snap-in Honeycomb Sides (No Supports)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Organize your Spice Cabinet! Beginner Friendly. No Supports Required! Honeycomb sides snap into place. Easy Clean Print
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 94
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Kinders, Meat Church, Good & Gather lovers all! Required a bigger spice organizer for varying sizes and cabinet space that didn't cost $15USD in filament or take 12 hrs to print. Created steps, modified dimensions, hallowed the base and added sides for support. Designed so your larger items go on the back, medium sized center, and smaller up front (as shown in picture)
No glue needed. Sides snap into place (if you want, add a little glue along the rails)
Printed in PLA Basic and PLA Galaxy, but print in any filament type (probably not TPU) and use any color scheme you wish.
No supports needed. Use slicers lay on face feature and orientate base upwards if 3MF or STL does not populate as such. (3MF should save print settings for Orca Slicer)
If not, ensure honeycomb support brackets that snap into the sides are facing upward on the print bed (picture included)
Dimensions: X - 6" | Y - 8.5" | Z - 3.25"
Print times: Base - 3 hrs 33 min | Honeycomb sides (printed together) 2 hrs 27 min | Total - 6 hrs
Printed on Flashforge AD5X