avian 60 amp cooling fan mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was having some trouble with the esc on one of my rc airplanes overheating, so I built a cooling fan. problem solved
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 33
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This cooling fan is designed to fit on the avian 60 amp esc. The motor and a blade are available on amazon. The blade in the pictures is not the one on amazon, I used one I had laying around. The blade also might need to be trimmed slightly.
The motor will have to be pressed in, I designed it to be tight on purpose, and I just glued the mount onto the esc with hot glue onto the plastic parts of the esc, this allows the esc to be removable.
The model should be placed onto the ESC so that these are gaps under the sides of the mount but not the front and back, the wires should also be coming out the side that is corresponding to the battery leads on the esc.
I ran the cooling fan off of the battery port on my receiver, the motor will need a 330Ω resistor so that the motor doesn't burnout.
Print the model upside down, it will save you time and filament.
This model was printed out of Elegoo Black PLA and with a 0.4mm nozzle.
Motor: https://a.co/d/0az71Fdg
Blades: https://a.co/d/0hRZW3xO