Case for muzi ᴡᴏʀᴋꜱ Base Uno/Duo + Super IO
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This case can house the Base Uno/Duo and the Super IO expansion board from muzi ᴡᴏʀᴋꜱ.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 115
- Wydruki
- 2
- Wyświetlenia
- 523
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Open Community License v1
IMPORTANT, read the assembly instructions, DON'T tape the OLED screen to the base or OLED-bracket yet!
This is a case/enclosure for the Base Uno/Duo and the Super IO expansion board from muzi ᴡᴏʀᴋꜱ.
The case features a sliding on/off switch, D-pad buttons, a place to fit the GPS antenna, a place for 15mm magnets and can be assembled without additional hardware.
Assembly instructions:
Throw away the included bracket for the OLED screen
Print all parts, I suggest printing the buttons and slider in an accent color and the two case half's in a primary color
Place the screen and buttons in the top half of the case:
Place the modified OLED bracket on the screen. If you want, you can remove the protective film from the double-sided tape:
Place the Super IO + Base on the bracket. The antenna connector needs to snap into it's place, but be careful not to break the OLED, it's fragile. Only apply pressure when you're sure the OLED sits flush in it's cutout. If you don't plan to take the case apart again I recommend gluing the OLED into it's cutout in step 3.
Slide the flat-flex cable into it's connector.
Place the GPS antenna in it's compartment, make sure the cable can't be pinched by the case:
Use two of the included screws to screw the board into the top half:
Install the slider switch cover
(Optional) glue two 15mm diameter magnets into the bottom half of the case
Install the LiPo in the bottom half using double-sided tape
Use the 4 remaining screws to close up the case
Tighten the nut on the antenna connector.