TronXY X5SA Direct Drive Linear Rail Under Carriage Gantry
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is my design for a direct drive extruder setup on a TronXY X5SA (400 in my case) utilizing a linear rail (MGN12H)…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 1129
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This is my design for a direct drive extruder setup on a TronXY X5SA (400 in my case) utilizing a linear rail (MGN12H) mounted on the bottom side of the X-axis 2020 extrusion.
This gantry can use the supplied stepper, extruder, X end-stop, and Z sensor. You should be able to use any standard V6 extruder (titan, BMG, etc) as well. I'm using my own stepper motor and an E3D Titan on mine. The supplied stepper cable will likely not be long enough - so keep that in mind before you convert.
You will need a selection of m3 bolts and nuts. I'm using 6x 45mm to hold the front and back together but you'll need a handful of shorter ones to mount the motor, fan assemblies, cable clamps, etc.
I'm not ahuge fan of the under-side mount mainly because the GT2 drive cables are suspended above the railing. Holding the weight below and the drive above means there's probably a bit of torque and you might need to adjust speed/outer perimeter acceleration a bit to compensate. The whole reason I designed the under-mount was the 500mm linear rail was just a mm or two too long to fit between the Y-axis gantries - so be on the lookout for a redesign.
Given the style of cable clamps I strongly suggest you also utilize my motor mounts which let you adjust tension at the motor and not just at the cables. Those are available here: https://www.thingiverse.com/thing:4798455.
Video of it in action is available here: https://youtu.be/UfDU0BjnJ9I
Check out this and my other TronXY X5SA upgrades at: https://www.youtube.com/watch?v=B6CcgPO909s
The new 'above-rail' version is available here: https://www.thingiverse.com/thing:4852310
Print Settings
Printer:
TronXY X5SA-400
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament:
PolyMaker PLA
Notes:
STL orientation should be correct and no supports should be required except for the blower channel. You may want to use Bed Only supports - I printed with no supports - however do not try to print with all supports as it may not be possible to remove some of the internal ones.
Category: 3D Printing