Ethernet (cat5) Breakout Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Need to run eight light-gauge wires somewhere? Have spare 4x6cm prototyping boards and surface-mount screw connectors…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 266
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Need to run eight light-gauge wires somewhere? Have spare 4x6cm prototyping boards and surface-mount screw connectors lying around? Here is a solution for you!
I designed this to run thermistor, fans, and sensors lines to my hot end. Combine with stranded ethernet cable and you have a compact and flexible replacement for the mesh of disparate wires.
You'll need:
4x6cm Prototyping Boards: eg: https://www.amazon.com/gp/product/B0166GCD42/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
Surface Mount Screw Connectors: eg: https://www.amazon.com/uxcell-50Pcs-KF2EDGK-Terminal-Connector/dp/B06VX2WM85/ref=sr_1_6?keywords=uxcell+terminal+block&qid=1563927719&s=gateway&sr=8-6
Ethernet Wall Jack: eg: https://www.homedepot.com/p/Commercial-Electric-Category-5e-Jack-White-5025-WH/206427940
Then, of course some ethernet cable, solder, etc.
Of course you could also just buy one of these for a few bucks but what's the fun in that?!
The ethernet jacks are a snug fit. Make sure you wire and test them before inserting them into the caps.
Print Settings
Printer:
FT-5
Supports:
Yes
Notes:
High recommend printing the base on its back side (as opposed to bottom which seems more obvious). You'll deal with more supports but it will make the 'clips' on the base far stronger.
Category: Electronics