Boom box/radio very easy to build

This should be a very low costing project!!

500gm or half a role of filament ~$8.00USD

the speakers cost ~$14.00USD https://www.amazon.com/dp/B0BHST51PQ?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_1&th=1

the radio cost ~$10.00USD   https://www.amazon.com/dp/B0CR1P4XJY?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1

the screws cost about ~$1.50USD you can find them at your local hardware store

these are the screws that I used https://www.amazon.com/dp/B08QF455PJ?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_9

Cut the speaker wires about 1in form the connection then strip the wires, and solder then together with matching colors red with red and black with black. with the small speaker the original wires broke off so I soldered some new ones on and made them slightly longer but you don't have to put new wires on it will work without doing that. So at the end you should have one speaker connection! At this point you should have all the parts printed out. So, connect Left front and Right front using filament and slip joint plyers press about 3/4 long filament in the holes. use the little snipper thing on the plyers to cut the filament about the same size please note that it takes a bit of patience to get them in. Press and screw the four box speakers in and the little one, just screw it in. Use the same filament and plyers method to connect the Left Back and Right Back together. Connect the radio board to the designated spot, again use whatever screws work. Connect the front assembly to the back assembly using filament. Attach the battery pack to the Battery panel then screw the assembly on to the bottom with any screws. Use tweezers to clear out the support material for the antenna, use whatever screws' work

                                                               Congratulations you did it!