Ford Maverick FITS Seat Bar (2022 Ford Maverick)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a bar with a FITS slot on it. This is designed to slot into the bag holders I made. I put a little screw on…
- Ocena
- 4 / 5
- Polubienia
- 52
- Pobrania
- 195
- Wydruki
- 1
- Wyświetlenia
- 2014
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a bar with a FITS slot on it. This is designed to slot into the bag holders I made. I put a little screw on each end so it doesn't slide out - gonna add holes eventually. I printed this on a Creality Ender 3 with eSUN PETG using the following settings:
Print Temperature: 245
Plate Temperature (Initial Layer): 80
Plate Temperature: 70
The rest of my settings were autoapplied via the eSun PETG with 0.4mm nozzle extruder settings in Cura 4.13.
Print time total was 9 hours 11 minutes.
Fitment was tested in the seat hooks - snaps in as expected.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Yes
Supports:
Yes
Resolution:
0.2
Infill:
20%
Filament: eSun PETG Orange
Category: Automotive