Ford FITS LP Cupholder With Cable Mount (2022 Ford Maverick)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is remix of the low profile cupholder done by RedBaron97. I added a 3M cable grabber onto the flat section I…
- Ocena
- 5 / 5
- Polubienia
- 44
- Pobrania
- 315
- Wydruki
- 1
- Wyświetlenia
- 2496
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
This is remix of the low profile cupholder done by RedBaron97. I added a 3M cable grabber onto the flat section I added between the cupholder holes so I could route a cable for charging an android tablet / phone on the road. I printed this on a Creality Ender 3 with eSUN PETG using the following settings:
Print Temperature: 245
Plate Temperature (Initial Layer): 80
Plate Temperature: 70
The rest of my settings were autoapplied via the eSun Black PETG with 0.4mm nozzle extruder settings in Cura 4.13.
Print time total was 9 hours 25 minutes.
Fitment was tested in rear center console slot.
Original Model: https://www.thingiverse.com/thing:5121962
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Yes
Supports:
No
Resolution:
0.2
Infill:
20
Filament: eSun PETG Black, Orange
Category: Automotive