1 / 2
Ammo Box 5 for .338 Lapua
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
Requires two magnets 5x3mm to keep lid in place when closed (https://www.amazon.de/dp/B0FYWW6228 e.g.).
Clearance between box and lid is configured as 0.2mm. Depending on used printer, filament and settings lid could be a bit loose. But I decided to keep 0.2mm since with 0.1mm on Snapmaker lid got stuck and needed some postprocessing with sand paper.
Testprints:
Prusa MK3S + Prusa Jet Black PLA: fits with 0.2mm
Prusa MK3S + Prusa Army Green PLA: bit loose, 0.1mm were better
Snapmaker 2.0 + Snapmaker black PLA: fits with 0.2mm
Constructed from the scratch as parametrized box in SOLIDWORKS for Makers