Parametric Wet/Dry Vacuum Accessories Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Brackets to hold Wet/Dry Vacuum Accessories to 1.5" PVC pipe.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 38
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
Years ago I built a PVC pipe supported stand to hold a cyclonic separator above my wet/dry vacuum in the shop. The locations for the pipe took up built-in locations to hold the tubes and other accessories. This led to endless searching for items. Enter the solution: holders that mount to the 1.5" PVC uprights.
This set includes two pieces that hold the tubes and accessories with a very satisfying snap and a compliant release. The tubes need a lower and an upper print. It could use two uppers, but wouldn't give the tubes a surface to sit on. The brackets have countersunk holes to be screwed to the PVC after drilling a pilot hole. The screws I used were approximately 1 cm long wood screws.
The Fusion 360 file is parametric if your PVC or accessories are different from mine.