1 / 3
Gira DualQ  Rauchmelder Aufputzhalterung / Smoke detector surface-mount bracket — zdjęcie 1
1 / 3

Gira DualQ Rauchmelder Aufputzhalterung / Smoke detector surface-mount bracket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Surface-mount ceiling bracket for Gira Dual Q with side cable entry (KNX) Aufputz-Deckenhalter für Gira Dual Q

Ocena
0 / 5
Polubienia
0
Pobrania
14
Wydruki
0
Wyświetlenia
72
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

ENG:

Surface-mount ceiling bracket for the Gira Dual Q with a side cable entry (e.g. KNX). Great for neat cable routing when running cables on-surface.

Compatibility

  • Designed for Gira Dual Q mounting ring

Details

  • Material: designed for PLA (PETG/ABS also possible)

  • Ceiling mounting: standard countersunk screws

  • Mounting the detector’s mounting ring: 15 mm device screws (commonly used for flush-mount boxes)

  • Cable entry: side hole Ø 10 mm

  • Printing: no supports required

Print suggestions (recommended)

  • 0.2 mm layer height, 3–4 perimeters

  • 20–30% infill

  • 5–6 top/bottom layers

  • 0.4 mm nozzle

Important note

  • Not an official Gira accessory. Use at your own risk. Consider fire safety regulations.

  • Please do a quick test fit before final installation (printer/material tolerances vary)

DE:


Aufputz-Deckenhalter für den Gira Dual Q mit seitlicher Kabeleinführung (z. B. KNX). Ideal, wenn das Kabel aufputz geführt wird und sauber in den Melder eingeführt werden soll.

Kompatibilität

  • Designed for Gira Dual Q mounting ring (Tragring)

Details

  • Material: für PLA ausgelegt (PETG/ABS je nach Bedarf möglich)

  • Deckenmontage: mit normalen Senkkopfschrauben

  • Befestigung Tragring: mit 15 mm Geräteschrauben (wie bei Unterputzdosen üblich)

  • Kabeleinführung: seitliches Loch Ø 10 mm

  • Druck: ohne Support druckbar

Druckempfehlung (Vorschlag)

  • 0,2 mm Layer, 3–4 Perimeter

  • 20–30 % Infill

  • 5–6 Top/Bottom Layer

  • 0,4 mm Düse

Wichtiger Hinweis

  • Kein offizielles Gira-Zubehör. Nutzung auf eigene Verantwortung. Brandschutz beachten.

  • Vor der finalen Montage bitte einmal Test-Fit (Toleranzen je nach Drucker/Material).

Tagi