1 / 3
Meta Quest 3 BoboVR velcro fastener extension — zdjęcie 1
1 / 3

Meta Quest 3 BoboVR velcro fastener extension

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Extension for the Velcro fastener of the BoboVR M3 / S3

Ocena
0 / 5
Polubienia
1
Pobrania
7
Wydruki
0
Wyświetlenia
56
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Wenn deine Rübe zu groß ist und der Klettverschluss der BoboVR nicht lang genug, um ihn durch die Lasche an der Quest 3 zu ziehen, kannst du diese einfache Verlängerung nutzen.

Zumindest PETG ist zäh genug, um den Zug auszuhalten. Mit 100% infill braucht es nur 1,14g Filament.

Die Länge ist über Parameter anpassbar. In der .stl sind es ca. 30mm.

Das Einfädeln in die Meta kann etwas knifflig sein, ich habe daher ein kurzes Stück als Hilfe an das eigentliche Modell "angebaut". Wenn es stört, kann es später einfach abgeschnitten werden.

_______

If your head is too big and the Velcro fastener on the BoboVR isn't long enough to pull it through the tab on the Quest 3, you can use this simple extension.

At least PETG is tough enough to withstand the pull. With 100% infill, it only needs 1.14g of filament.

The length can be adjusted via parameters. In the .stl file, it is approx. 30 mm.

Threading it into the Meta can be a bit tricky, so I have “attached” a short piece to the actual model to help. If it gets in the way, it can simply be cut off later.