The TRULY Perfect Spool Holder (M3 Reinforced)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Because "perfect" wasn't sturdy enough. Now with M3 bolts, a sync-bridge, and actual stability for serious makers.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 104
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Why This Remix Wins
The original was a good start, but this version fixes the "perfect" flaws that others ignored.
Real Hardware: I replaced weak friction fits with M3 bolts and nuts because "sturdy" should actually mean something.
The Sync-Bridge: I added a mechanical bridge to lock the rails together, ensuring they move apart evenly instead of drifting like the original.
Anti-Bowing Security: Added additional bolts to keep the frame locked tight—this holder won't flex or bow even under heavy 2kg spools.
Pro Traction: Don't let your spool slide; the rubber band hack turns "gliding" into actual rolling.
Stay-Put Engineering: Stop the "walk" by using rubber feet stickers and internal extra weight so it stays exactly where you put it.
The "Everything You Need" Hardware List
Don’t show up to the workbench unprepared. If you want actual stability, you’ll need this exact hardware:
4x M3 x 8mm Hex Bolts: Specifically used to secure the sync-bridges so your rails don't go on a solo mission.
8x M3 x 20mm Hex Bolts: These provide the actual structural integrity and hold the rollers in place—unlike friction fits that give up after a week.
8x M3 Nuts: Because we’re building a tool here, not a LEGO set.
4x 608ZZ Ball Bearings: For that buttery-smooth spin that the original could only dream of.
4x Rubber Feet Stickers: Unless you like chasing your spool holder across the table during a retraction.
4x Rubber Bands: Stretch these over the rollers. It gives the spool "traction"—look it up.
Internal Weight: Stuff some lead or heavy scrap inside the base. A light spool holder is a useless spool holder.
Recommended Print Settings
Don't come crying to me if you print this with 15% infill and it breaks.
Walls: 5 Perimeters—anything less is just a toy. (Wait... you actually believe that? 2 perimeters is enough, don't go for overkill here)
Infill: 40% Gyroid for that satisfying "thud" when you set it down. (If you’re a coward, 15% works fine, but don't tell the others)
Layer Height: 0.2mm.