Sovol Eddy CN3D v4 Probe Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I took the Eddy probe mount and remixed it to fit the Sovol Eddy version of the probe.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 175
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Nadir's probe options do not include the Sovol Eddy version of the Eddy probe. This places the bottom of the enclosed Sovol Eddy right at the base of the extrusion mount, which appeared to be the same targeted location from the v4 BTT Eddy version. By my measurement that left the Sovol Eddy about 3.1mm above the nozzle. I was able to get that to work by adding tap speed as mentioned below.
In case you are on the same path as I have been, I got the Sovol Eddy working with the Sovol provided Klipper Firmware using this github thread: https://github.com/Rappetor/Sovol-SV08-Mainline/issues/230. After switching to the v4 for some reason tap was failing. When I added "tap_speed: 5" to my eddy config it started working again.
[probe_eddy_ng eddy] sensor_type: ldc1612 i2c_mcu: extra_mcu #i2c_bus: i2c1 # can be used to replace software serial if STM32F103 errata regarding i2c hangs is implemented in Klipper #i2c_speed: 100000 # Klipper only implements 100k i2c rate in hardware, software i2c works at 400k i2c_software_scl_pin: extra_mcu:PB6 i2c_software_sda_pin: extra_mcu:PB7 x_offset: 0 y_offset: -35 #reg_drive_current: 22 # from calibration performed by the autor of the PR LupusTheCanine home_trigger_height: 1.8 tap_speed: 5