Wall Bracket for Anker 100W 4-Port Charging Station

This is a wall mounting bracket for the Anker 100W 4-port charging station that I have that I designed back in early 2021. Since I wanted it to be wall mounted i left the port-side open so it could be easily removed if needed. fasteners are hidden to make the design as compact as possible and not have any ugly mounting flanges sticking out the side. Designed to mount using two #6 countersunk screws as shown in the pictures. Hole in the bottom of the bracket allows for the power cable accessibility. Can be printed with and without supports depending on your preferred print orientation. I have not tried it with their new 120W version but if the dimensions are roughly the same as the 100W dimensions, 34mm X 85.15mm X 110.25mm with the plug in the bottom center then it should work for that one as well.  When installing make sure to leave enough clearance for the charging station to be able to drop in. Desk mounting is possible but not advised since this design does not prevent the charging station from sliding out without a latch or an additional restraint.