Handle for Eibos Cyclopes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stylized handle to make working with the Cyclopes easier.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 128
- Wydruki
- 9
- Wyświetlenia
- 1188
- Oceny
- 9
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an easy to install handle for the Cyclpes. It's the first model i've shared, and it represents a few expirements I was doing with PrusaSlicer. I also incorporated some FFM design principles I've been reading about. It's not perfect, but I hope someone finds it useful. As many have noted, while the cyclopes is a good option, working with it typically requires a juggling act of removing the cover and trying to hold it while working with the spools. This handle makes it much easier, and as a bonus, keeps my fingerprints and smudges to a minimum.
Most of the settings and slicer modifications are enclosed in my .3mf file. Feel free to ask if you have any questions. Be sure to orientate the model so that the triangles built into the bolt holes and counterbore are pointing up. They'll keep the holes nice and round for printing without supports.
Lastly, you'll need two M6 x 30 socket head cap screws and two M6 jam nuts (the thin ones). Apologies for specing non-standard hardware. The whole point of orientating the handle this way was to utilize the pre-existing holes in the cover. They are 6mm.